Wall&Water
The BerryAlloc Wall&Water collection is ideal for wet, humid rooms.
The panels can withstand direct contact with water, which has earned them the Scandinavian ‘wet room’ approval. These walls are the right choice, both privately and professionally, for bathrooms, public showers and dressing rooms, among others.
It is the only technology that produces the effect of a tiled wall so quickly and easily – without the need to mess with joint mortar. Our walls are so user-friendly, hygienic and durable that they come with a lifelong warranty for private use. These durable panels consist of a layer of high-pressure laminate (HPL) on top of seven layers of plywood.
You can choose from 11 colours with different tile structures and different finishes (high-gloss or silky), allowing a total of 28 variations. A match for every taste and interior.
Uses
Bathrooms- Wet zones
- Everywhere you want tile walls
Installation
STEP 1
Build a wooden squared studwork with centre-to- centre spacing of 600 x 800 mm. The wooden base must be level and offer sufficient hold for screws.
STEP 2
Install the base profiles: Secure the backside of the base profiles with sealant and screw them to the wall. Make sure that they are mounted perfectly in level.
STEP 3
The inner corner profile consists of two parts. Screw the inner part to the framework. Make sure that it is mounted perfectly vertical.
STEP 4
Add sealant on top of the lip on the base profile and in the slot of the corner profile.
STEP 5
Install the first panel: Start to the right of any of the inner corner profiles. Measure the width to the center of the first vertical stud in the framework. Cut the panel in its proper width. Place the panel onto the base profile and press into slot in the corner profile. Make sure it is leveled.
STEP 6
Screw the panel to the stud in the framework each 20 cm.
STEP 7
Add sealant on the base profile and in the groove on the previously installed panel (in wet areas).
STEP 8
Install the next panel and screw it to the framework.
STEP 9
Mounting the final panel, meeting an inner corner profile: Cut the panel in its proper width.
Add sealant on the base profile and in the slot of the inner corner profile. Press the panel into slot in the corner profile.
STEP 10
Add sealant on the inside of the inner corner frame and press the frame into the inner part of the corner profile.